Please Sign In to display your prices

Surfkoat PolyPack Tint Packages 32oz. Package

Product Availability Price Add to Cart
Medium Gray
SUF 005 PPK01 14MG
In Stock
$58.70 QT
Sun Buff
SUR 005-PPK01-14SD
In Stock
$51.81 EA
White
SUR 005-PPK01-14W
In Stock
$51.81 EA

Polypack is a high solids, concentrated, solvent based tint system specially formulated for PolyKoat GL polyaspartic polyurea. Polypack is formulated with high quality, ultra fine particle pigments that easily disperses in PolyKoat GL. Polypack is a superior choice to obtain a semi-transparent stain or a solid opaque colored finish in PolyKoat GL polyaspartic.

 

Recommended Applications:

  • Auto Service Centers
  • Warehouses
  • Laboratories
  • Aircraft Hangars
  • Cafeterias
  • Garages
  • Many other concrete surfaces where a solid color polyaspartic is desired

 

SURFACE PREP:

  • Concrete surface must be clean and free of all contaminants and water. Do not apply if rain is forecast within 24 hours. If moisture is present or if the surface is not clean and free of all contaminants, the sealer may have white spots and have premature delamination and failure. Review the technical data and MSDS for the chosen polyaspartic prior to use for surface prep instructions, application instructions, coverage rates and limitations. Substrate and air temperature must be no less than 40° F and not exceed 80° F. If applied outside these limits the sealer may not achieve adequate film formation and may have excessive air entrapment, bubbles, blushing or hazing. Note that in direct sunlight, substrate temperature can exceed 150° F which can cause extreme bubbling issues.

MIXING:

  • Mix desired amount in approved polyaspartic Part A for 1-2 minutes using a squirrel mixer at a low speed to avoid introducing air to the product prior to mixing parts A & B. Material may separate during long term storage. Remix as needed.

USAGE RATE:

  • Solid Opaque Finish: 9 ounces per gallon
  • *Usage rates are suggested amounts only! Due to varying polyaspartic compositions, substrates, surface texture, porosity and desired look a test area is recommended to achieve desired results.

APPLICATION:

  • Review the technical data and MSDS for the chosen polyaspartic prior to use for surface prep instructions, application instructions, coverage rates and limitations.

FOR PERSONAL PROTECTION USE GLOVES, GOGGLES, AND RESPIRATORS.

CAUTION: Do not add too much color! Apply a test area prior to job application for desired appearance. Over pigmenting may cause color float or streaking, especially in the darker colors! Do not allow to puddle! The average usage is 9 oz. gallon of material for most opaque applications. For lighter colors it may take more and darker colors may take less depending on the application as well as the composition of the polyaspartic. Check Polypack for compatibility with competitors’ polyaspartic prior to use!

 

PLEASE NOTE: It is always recommended to test the product in a small, inconspicuous area (on the same concrete substrate) for desired results prior to application. Coverage rates may vary for all coatings and substrates depending on porosity, density, texture etc. When applying, do not exceed 400 sq. ft. per gallon. Applying too thin of a coating may cause inadequate film formation or performance expectations may be limited. DO NOT USE ON BRICK.

 

CLEAN-UP:

  • Use xylene. Dispose of containers in accordance with local, state and federal regulations.

PRODUCT REMOVAL:

  • Refer to polyaspartic technical data sheet.

SHELF LIFE:

  • Up to one year from manufacture date in its original, unopened container stored at room temperature.

PACKAGING:

  • Available in 1 quart containers. Always read all technical information, label and SDS prior to use.

 

Pending Reviews